2ef7 map thermostat activation code install#

Install splash shields and fill and bleed cooling system. Jr Typing Tutor Serial Key.ДЄ small amount of new coolant can be used to lubricate coolant hose O-rings, this will make installing hose easier. Install coolant hoses, listen for an audible click to confirm that clips have engaged. Install new thermostat and evenly tighten fasteners. Be prepared to catch the excess coolant that may leak in a container. Figure 12 Then remove the thermostat from the front, over the subframe. See our tech article on Remove the radiator. See our tech article on Drain cooling system. So I say just go for it and make your life easier no matter which model you own. If you have an all wheel drive E90 or one with active steering, you're going to have to remove the radiator anyway. I like to remove the radiator when I have to replace a thermostat, it adds time to the job, but makes it a lot easier. This can be a tough part to change as it is tucked away and behind many components. A fault code can be present yet the vehicle will lack any cooling system issues, such as overheating. If a fault occurs a code is stored in the DME, usually with a description of 'Map cooling circuit'. The DME (engine control module) controls and monitors operation of the thermostat. The thermostat is mounted to the right side of the engine at the front.